once the scan is complete i press to clean up and it gives me an error message to update code...which i have already
Page 1 / 1
Hi candysway
Welcome to the Community Forums.
What I would do in this case is once the scan is complete I would not do anythiing more but rather I would reboot your system. Once rebooted I would then run a scan again to see if you get the same occurrence.
If you do then please post back and I think that we will then have to look at an uninstall/clean reinstall of WSA.
Regards, Baldrick
Welcome to the Community Forums.
What I would do in this case is once the scan is complete I would not do anythiing more but rather I would reboot your system. Once rebooted I would then run a scan again to see if you get the same occurrence.
If you do then please post back and I think that we will then have to look at an uninstall/clean reinstall of WSA.
Regards, Baldrick
Reply
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.