What is the correct syntax for registry commands via the console (Agent Commands / Advanced / Run a registry command)?
Online help does not give any example, only says this short advice:
"This command uses the same syntax as reg.exe, but does not call reg.exe"
So I tried issueing the following command:
ADD HKLMSoftwareMicrosoftWindowsCurrentVersionPoliciesExplorer /v NoDriveTypeAutoRun /t dword /d 000000ff
but the I dit not succeed, even if the "View commands for selected endpoint" log says that it was executed.
(And BTW, why does not this log shows back any result?)
So what is the correct syntax?
+56So it looks like your sytanx is correct, so it could be a bug in this feature. If you wouldn't mind, please create a ticket here:
https://www.webrootanywhere.com/servicewelcome.asp?SOURCE=ENTERPRISEWSA
so that we can get it documented and escalated to the right folks. I'm also tracking down some documentation on syntax for that feature to send you, just so you have it.
https://www.webrootanywhere.com/servicewelcome.asp?SOURCE=ENTERPRISEWSA
so that we can get it documented and escalated to the right folks. I'm also tracking down some documentation on syntax for that feature to send you, just so you have it.
Same issue here, the registry command get executed but the registry key is not delete in my case
check here:
http://prntscr.com/km5bnz
check here:
http://prntscr.com/km5bnz
+35I would recommend that you open a ticket with our support team, as this may be specific to your instance.
Reply
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.